HP 83751A User Manual page 104

IP
When this function is selected (by pressing [SHIFT) [WI), the current
preset mode (factory or user) is shown in the right-hand display of the
sweeper. The mode can be changed by pressing the @J @ keys, or by
turning the front panel knob. The preset mode choices are:
When C-J is pushed, the instrument is returned to a
Factory
factory-defined state. (See 'fable 8-l in this section.) The
right-hand display shows
When @KY] is pushed, the instrument is returned
to a user-dehned state. The right-hand display shows
SYSTem:PRESet:TYPE FACTory
SYSTem:PRESet:TYPE USER
Associated SCPI Commands
Returns the instrument to the preset
Associated 8350 Commands
Returns the instrument to the preset
state.
Associated SCPI Commands
Sets the preset mode to "factoqc '
Sets the preset mode to 'user."
Instrument State Keys
8 - 5