How Do I Use The Remote Interface; Figure 2-1 Gpib Cable; Figure 2-2 Rs-232 Cable - Keithley SourceMeter 2611 User Manual

2-2 Remote Operation

How do I use the remote interface?

Reference
Step 1: Connect to the interface
Refer to
(IEEE-488) and RS-232 connectors, and make connections as follows:
•
•
Figure 2-1
GPIB cable
Figure 2-2
RS-232 cable
2600S-900-01 Rev. A / May 2006
Refer to Section 11 of the Series 2600 Reference Manual for
detailed information on communications interfaces.
Figure 1-2 in Section 1 of this document for the locations of the GPIB
GPIB – Use a shielded IEEE-488 cable such as the Keithley Instruments
Model 7007 to connect the Series 2600 IEEE-488 connector to the GPIB
connector on the computer (Refer to
RS-232 – Use a shielded 9-pin RS-232 cable like the Keithley Instruments
Model 7009-5 to connect the SourceMeter RS-232 connector to the serial
port of the computer (Refer to
Straight-through RS-232 Cable
Return to
Series 2600 System SourceMeters User's Manual
Figure 2-1).
Figure 2-2).
In this Section: