How Do I Use Other Programs; Using Labview - Keithley SourceMeter 2611 User Manual

2-12 Remote Operation

How do I use other programs?

Reference
Basic source-measure examples using LabVIEW and Visual Basic are shown
below. Refer also to also Section 3 for more examples of how to load and
run scripts.

Using LabVIEW

The source-measure example using LabVIEW is shown in
steps are:
1.
2.
3.
4.
5.
6.
The command sequence for this source-measure example is shown below:
localnode.prompts = 0
reset()
smua.source.func =
smua.OUTPUT_DCVOLTS
smua.source.levelv = volts
smua.source.output = smua.OUTPUT_ON --Turn on source output.
print(smua.measurei())
reset()
2600S-900-01 Rev. A / May 2006
Refer to the LabVIEW and Visual Basic documentation for details
on using those programs.
Reset instrument.
Select source voltage function.
Set source output voltage.
Turn on output.
Take current measurement.
Reset instrument.
Return to
Series 2600 System SourceMeters User's Manual
--Disable prompts.
--Reset Series 2600.
--Select voltage source function.
--Set voltage source level.
--Take and return current reading.
--Reset Series 2600.
In this Section:
Figure 2-7. The test