Keithley SourceMeter 2611 User Manual page 19

Series 2600 System SourceMeters User's Manual
1. CHANNEL A and CHANNEL B (Channel B on Models 2602/2612 only)
2. DIGITAL I/O
Enable. Use a cable equipped with a male DB-25 connector (Keithley Instruments part
number CA-126-1CA).
3. IEEE-488
7007-1 or Model 7007-2.
4. Cooling exhaust vent
overheating.
5. Chassis ground
6. Low noise chassis ground
7. RS-232
modem) DB-9 shielded cable for connection to the PC (Keithley Instruments Model 7009-
5).
8. TSP-Link
trigger and communicate with each other. Use a category 5e or higher LAN crossover
cable (Keithley Instruments part number CA-180-3A).
9. Power module
line voltages of 100V to 240VAC at line frequencies of 50Hz or 60Hz. Refer to Section 17
of the Series 2600 Reference Manual for line fuse replacement instructions.
Input/output connections for source, sense, and guard.
Female DB-25 connector. Fourteen pins for digital input or output, one pin for Output
Connector for IEEE-488 (GPIB) operation. Use a shielded cable, such as the Model
Exhaust vent for internal cooling fan. Keep vent free of obstructions to prevent
Ground screw for connections to chassis ground.
Ground jack for connecting Output HI or LO to chassis.
Female DB-9 connector. For RS-232 operation, use a straight-through (not null
Expansion interface that allows a Series 2600 and other TSP-enabled instruments to
Contains the AC line receptacle and power line fuse. The instrument can operate on
Return to In this section: 2600S-900-01 Rev. A / May 2006
Front Panel Operation 1-7