Figure 2-4 Instrument Console Control Icons - Keithley SourceMeter 2611 User Manual

Series 2600 System SourceMeters User's Manual
Figure 2-4
Instrument console control icons
Step 2: Open and close an instrument resource
Before you can send commands or run scripts to control the SourceMeter, you
must first open the instrument resource as follows:
1.
2.
Click on the Open Instrument icon (Refer to
Choose the desired instrument from the dialog box (Refer to
drop-down menu to select a communications resource:
• GPIB – At the factory, the GPIB address for the SourceMeter is set to
26. If using the GPIB interface board 0 and address 26, the resource
setting should be GPIB0::26::INSTR. Resource settings for other GPIB
board numbers and primary addresses are available from the dialog
box.
• RS-232 – Typically, the COM1 serial port of the PC is used for RS-232
communications. For COM1, use the ASRL1::INSTR resource setting.
Resource settings for other COM ports are available from the dialog
box.
Return to
Figure
In this Section: 2600S-900-01 Rev. A / May 2006
Remote Operation 2-7
2-4).
Figure 2-5)