Enable Fips Mode; Corporate And Personal Directories Setup; Corporate Directory Setup - Cisco 8821 Administration Manual

Cisco Unified Communications Manager Phone Configuration
Procedure
Step 1 In Cisco Unified Communications Manager Administration, choose Device > Device Settings > Phone
Services.
Step 2
Set up the services.
Step 3 Verify that your users have access to the Self Care portal.

Enable FIPS Mode

Procedure
Step 1
In Cisco Unified Communications Manager Administration, select Device > Phone and locate the phone.
Step 2 Navigate to the Product Specific Configuration area.
Step 3 Set the FIPS Mode field to Enabled.
Step 4 Select Apply Config.
Step 5 Select Save.
Step 6 Restart the phone.

Corporate and Personal Directories Setup

You can make it easy for your users to contact coworkers using a corporate directory.
You can also enable users to create personal directories. Each individual user has a personal directory, which
they can access from any device.
The corporate and personal directories are set up in the Cisco Unified Communications Manager.

Corporate Directory Setup

The Corporate Directory allows a user to look up phone numbers for coworkers. To support this feature, you
must configure corporate directories.
Cisco Unified Communications Manager uses a Lightweight Directory Access Protocol (LDAP) directory to
store authentication and authorization information about users of Cisco Unified Communications Manager
applications that interface with Cisco Unified Communications Manager. Authentication establishes user
rights to access the system. Authorization identifies the telephony resources that a user is permitted to use,
such as a specific phone extension.
For more information, see the documentation for your particular Cisco Unified Communications Manager
release.
Cisco Wireless IP Phone 8821 and 8821-EX Administration Guide for Cisco Unified Communications Manager
Enable FIPS Mode
55