Not Ready, Cleaning Cartridge Installed; Hardware Error Sense Key; Hardware Error, General; Hardware Error, Tape Drive - Sun Microsystems storagetek sl500 Reference Manual

Modular library system
Hide thumbs Also See for storagetek sl500:
Table of Contents

Advertisement

Request Sense

Not Ready, Cleaning Cartridge Installed

The library is performing an Auto Clean function on the data transfer element
(tape drive) requested.
Note – While the cleaning cartridge remains in the drive, the library processes host
commands normally. If a host requests a data mount to the drive being cleaned,
then the library rejects the command and sends the Not Ready sense key (02), with
ASC 30 and ASCQ 03 (Cleaning Cartridge Installed).
The host receives the data mount error for the duration of the cleaning time.
Cleaning times vary, depending on the type of drive, the cleaning cartridge, robotic
times, and potential retry operations. The time required to clean a 9840 is about 30
seconds. The time required to clean a DLT drive varies with the number of times
the cleaning tape is used. The tape is good for 20 uses. Each time you use it takes
longer than the last time because the operation goes farther on the tape cartridge.
The longest cycle, cleaning cycle (20), takes approximately 5 minutes and 15
seconds.

Hardware Error Sense Key

The library generates a Hardware Error sense key if a hardware or firmware error
is detected during command execution. The following pages describe the
conditions that generate hardware errors.

TABLE 6-87 Hardware Error Sense Keys

Description

Hardware Error, General

Hardware Error, Tape Drive

Hardware Error, Cartridge Access Port
Hardware Error, Imbedded Software
Hardware Error/Media Load/Eject Failed
Hardware Error, General
The library generates a general hardware error when it detects an internal
electronics error during a command. This includes the electronics, vision system,
and robotics of the library.
Hardware Error, Tape Drive
The library generates a tape-drive error when an operation to the drive fails. The
problem could be the tape drive or the interface between the library and tape drive.

Hardware Error, CAP

The library generates a hardware error when the CAP fails.
214 SL500: Interface Reference Manual • July 2008
Sense Key
ASC
4h
40h
4h
40h
4h
40h
4h
44h
4h
53h
Revision: F • 96122
ASCQ
01h
02h
03h
00h
00h

Advertisement

Table of Contents
loading

Table of Contents