Mode Select (10) Data; Mode Select (10) Parameter Header; Table 6-28 Mode Select Parameter Header - Sun Microsystems storagetek sl500 Reference Manual

Parameter List Length

Mode Select (10) Data

The initiator must provide mode parameter data in a parameter list including:
"Mode Select (10) Parameter Header" on page 117
■
"Fibre Channel Logical Unit Page" on page 118
■
"Low Voltage Differential SCSI Logical Unit Page" on page 119
■
"Fibre Channel Port Control Page" on page 120
■
"Low Voltage Differential SCSI Port Control Page" on page 121
■
"Informational Exceptions TapeAlert Page" on page 122
■
"Element Address Assignment Mode Page" on page 124
■

Mode Select (10) Parameter Header

The library returns a 8-byte Mode Select parameter header as follows:

TABLE 6-28 Mode Select Parameter Header

Byte 7
0
1
2
3
4
5
6
7
Note – The header definitions for the library must be all 00h.
96122 • Revision: F
00h = No data transferred
■
A value of 00h is not considered an error.
Any other value is considered an error and is not supported.
14h = Mode Parameter Header and Informational Exceptions TapeAlert
■
Mode Page are transferred
1Ch = Mode Parameter Header and Element Address Assignment Page are
■
transferred
10h = Mode Parameter Header and Logical Unit Page are transferred
■
10h = Mode Parameter Header and Port Control Page are transferred
■
6 5 4
Reserved (00h)
Reserved (00h)
Reserved (00h)
Reserved (00h)
Reserved (00h)
Reserved (00h)
Reserved (00h)
Reserved (00h)
or
Bit
3 2
Chapter 6 SCSI Commands 117
Mode Select (10)
1 0