To Connect The Data Network Fiber-Optic Cable - Sun Microsystems StorEdge N8600 Filer Upgrade Manual

To Connect the Data Network Fiber-Optic Cable

Perform this procedure for each partner group that you are adding to the Sun
StorEdge N8600 Filer.
1. Connect a fiber-optic cable to the MCU array of a partner group.
Use a Media Interface Adapter (MIA) to connect the fiber-optic cable as shown in
FIGURE 2
Power supply LED
Power switch
AC LED
Interconnect cards
Array Back Panel Details
FIGURE 2
2. Connect the other end of the fiber-optic cable to the next available port of the
MCU FC-AL hub as shown in
3. Connect a fiber-optic cable to the alternate MCU array of a partner group.
Use a Media Interface Adapter (MIA) to connect the fiber-optic cable as shown in
.
FIGURE 2
4. Connect the other end of the fiber-optic cable to the next available port of the
alternate MCU FC-AL hub as shown in
AC power
MIA
FC-AL data port
.
FIGURE 3
FIGURE 3
Sun StorEdge N8600 Filer Storage Upgrade Guide
Power and
cooling unit
RS-232 serial port
(COM)
10BASE-T Ethernet
management host
interface port (RJ-45)
Controller card
Fiber-optic cable
.
9