Table of Contents
Advertisement
To Connect the Data Network Fiber-Optic Cables
Perform this procedure for each partner group that you are adding to the Sun
StorEdge N8400 Filer.
1. Connect a fiber-optic cable to the MCU array of a partner group.
Use a Media Interface Adapter (MIA) to connect the fiber-optic cable as shown in
on page 7.
FIGURE 2
Power supply LED
Power switch
AC LED
Interconnect cards
Array Back Panel Details
FIGURE 2
2. Connect the other end of the fiber-optic cable to the next available port of the
MCU Fibre Channel Arbitrated Loop (FC-AL) hub as shown in
3. Connect a fiber-optic cable to the alternate MCU array of a partner group.
Use a Media Interface Adapter (MIA) to connect the fiber-optic cable as shown in
on page 7.
FIGURE 2
4. Connect the other end of the fiber-optic cable to the next available port of the
alternate MCU FC-AL hub as shown in
AC power
MIA
FC-AL data port
FIGURE 3
Sun StorEdge N8400 Filer Storage Upgrade Guide
Power and
cooling unit
RS-232 serial port
(COM)
10BASE-T Ethernet
management host
interface port (RJ-45)
Controller card
Fiber-optic cable
FIGURE 3
on page 9.
on page 9.
7
Advertisement
Table of Contents
