Leica CM1860 Instructions For Use Manual page 21

Transport to the site
• When transporting the instrument on wheels,
(2) grip the cabinet only at the marked loca-
tions ( ).
• To ensure a secure upright position at its in-
tended location, the instrument must be adjusted.
To do so, unscrew both adjusting feet (1) using
the provided open-end wrench (No. 13).
When subsequently transporting the instru-
ment any further on wheels, screw them back
in all the way.
Leica CM1860 /CM1860UV – Cryostat
• First, check if the location meets the conditions specified in 'Installation
site requirements'.
• Transport the instrument to the desired location.
• Observe the following:
The instrument must be transported in an upright position or slightly
tilted (max. 30°)!
When tilting the instrument 2 people must counterbalance from the
front side to prevent the instrument from falling down and causing se-
vere injury, as well as possible severe damage to the instrument and
the surrounding area!
2
1
4. Setting up the Instrument
2 (not visible)
1
2
Fig. 9
21