Leica CM1860 Instructions For Use Manual page 20

4. Setting up the Instrument
6
• Lift and remove the wooden edge (6, Fig. 7).
• Remove the ramp (5, Fig. 8) on the front side
of the pallet (see Fig.
it to the back (see
• Properly insert the ramp. Make sure that the
ramp components designated "L" (left) and
"R" (right) click into place in the intended
guide channel (10,
assembled, the guide rails (11,
located inside, while the arrows (12
point toward each other.
Do not push the device by its hood (8,
Use the transport grip points (
The rollers (7,
• Carefully roll the instrument backwards over the ramp from the pallet.
• Push the instrument to the installation location on the castors (7,
The instrument must be transported in an upright position.
20
Fig. 7
6) and correctly attach
Fig. 8).
Fig. 8a). When correctly
Fig. 8a) are
Fig.
, Fig.
Fig. 8) must run over the ramp (5,
Transport
grip points
5
8a)
Fig. 8)!
8).
Fig. 8) at the front and rear. Danger of tipping!
8
5
7
10
12
11
Fig. 8).
Instructions for Use V 1.6 RevI – 10/2016
Fig. 8
Fig. 8a