Miscellaneous - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 2.0
6. When the keypad reads PARAMETER SAVED,
your selection has been configured.
D1260
1. Refer to Figure 2 on page 7 to access Keypad
Programming and navigate to the RPS
Parameters option. Press [ENTER]. The keypad
shows the RPS Passcode and the currently
configured passcode.
2. Press Phone Number softkey.
3. The keypad shows the currently configured
phone number.
4. Press the Edit softkey to change the phone
number.
5. The Pause and DT Detect (Dialtone Detect)
softkeys enter special characters. The
Backspace softkey allows you to erase
characters. The Clear softkey allows you to clear
the entire phone number. The [COMMAND] and
[ENTER] keys allow you to enter an * or a #. Use
the softkeys, the number buttons, and the
[COMMAND] and [ENTER] keys on the keypad
to enter the new phone number.
6. Press [ENT] to save the phone number.
7. When the keypad reads Parameter Saved, your
selection has been configured.
RPS Modem Speed
Default: 1200
Selection:
300, 1200, 2400
Select the baud rate for RPS-to-control panel
communication when using a PSTN connection.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Panel and Area Wide Parameters
2.7

Miscellaneous

Duress Type
Default:
Selection:
0 Do not send a duress event with any
passcode.
1 Increase the last digit by 1 to generate an
alarm. For example, if the passcode is 6123,
6124 activates a duress alarm.
If the last digit of the passcode is 0, a duress
alarm occurs when the user enters 1 as the
last digit of the passcode.
If the last digit of the passcode is 9, a duress
alarm occurs when the user enters 0 as the
last digit of the passcode.
2 Increase the last digit by 2 to generate an
alarm. For example, if the passcode is 6123,
6125 activates a duress alarm.
If the last digit of the passcode is 8, a duress
alarm occurs when the user enters 0 as the
last digit of the passcode.
If the last digit of the passcode is 9, a duress
alarm occurs when the user enters 1 as the
last digit of the passcode.
3 Send a Duress event when any Passcode with
L# Send Duress set to Yes is entered.
This program item determines when a passcode
entry with L# Send Duress authority should produce
a duress alarm.
Duress is enabled in Area Parameters by
setting A# Duress Enable to Yes.
The duress alarm activates when a user
enters the duress passcode followed by
the termination keys ([ESC] or [ENT]).
For SIA CP-01 Compliance
Duress Type must be set to 3.
0
0, 1, 2, or 3
EN | 30