Sdi Rps/Enhanced Communications Configuration; Route Group Parameters - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 6.0
6.7 SDI RPS/Enhanced
Communications Configuration
This section provides the necessary prompts for
configuring the SDI-Network Interface Module (NIM)
when using it for SDI RPS or SDI enhanced
communication applications.
Supervise SDI 88
Default: No
Selection: Yes or No
Yes Supervise the network interface
module (NIM) at SDI address 88.
No Do not supervise the network
interface module (NIM) at SDI
address 88.
This item determines whether the NIM is supervised.
If the NIM is supervised, disconnecting it from the
control panel creates a Trouble SDI 88 Event and the
keypad annunciates a trouble tone and displays
SERVC SDI 88.
Trouble SDI 88 or SDI 92 Reports are
always reported using the account
number for Area 1.
Supervise SDI 92
Default: No
Selection: Yes or No
Yes Supervise the network interface
module (NIM) at SDI address 92.
No Do not supervise the network
interface module (NIM) at SDI
address 92.
This item determines whether the NIM is supervised.
If the NIM is supervised, disconnecting it from the
control panel creates a Trouble SDI 92 Event and the
keypad annunciates a trouble tone and displays
SERVC SDI 92.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
AUXPARM
6.8

Route Group Parameters

The RG # Same Network Receiver parameters define
whether a primary and backup network receiver
configured within a Route Group are the same
receiver. This is required to ensure that the
authentication keys from the control panel to receiver
are the same when the paths to the receiver use
different IP Addresses or Port Numbers. These
parameters also enable the backup path poll time to
change to the primary poll time in the event of a
Communication Trouble condition. This operates
when the following conditions occur:

Both primary and backup devices use
enhanced communication via an SDI device.

Both primary and backup path destinations
are the same receiver that can be accessed
from more than one network such as on a
LAN/WAN and over the Internet (even if they
have different IP/port settings).

Either the primary or the backup path (not
both) has a Communication Trouble
condition.
RG # Same Network Receiver
Default:
Selection:
Yes
No
For Example: This would be used when a DX4020 is
reporting to a receiver over a LAN/ WAN and an
ITS-DX4020-G is reporting to the same receiver over
the Internet from the cellular service provider. This
configuration also typically has the poll rate for the
ITS-DX4020-G set to a slower poll rate than the
primary, such as every 4 hours.
No
Yes or No
The control panel uses the same
authentication keys to communicate
with both the primary and backup
paths. Upon detection of a
Communication Trouble on either
the primary or backup enhanced
communication paths, the working
path immediately changes to the
faster poll rate.
The control panel uses separate
authentication keys to communicate
with the primary and backup
receivers. Upon detection of a
Communication Trouble on either
the primary or backup enhanced
communication paths, the working
path continues to use its configured
poll rate.
EN | 122