Bosch D7212GV3 Program Entry Manual page 28

D7212GV3 | Program Entry Guide | 2.0
The Log Overflow Event is not sent to
the central station unless Expanded
Test Report is programmed Yes.
Failure to program the RPS telephone
number and the RPS IP address results
in a FAIL TO CALL RPS trouble event
sent to the central station when the log
threshold is reached. Refer to the RPS
Phone # prompt on page 29 for
information about programming the RPS
telephone number. Refer to RPS IP
Address # on page 115 for information
about enabling network RPS.
Contact RPS if Log % Full
Default: No
Selection:
Yes or No
Yes Directs the control panel to
automatically communicate with
Unattended RPS over network or
phone when Log Threshold is
reached.
No The control panel will not
automatically contact RPS when Log
Threshold is reached.
When the event log reaches the percentage full
indicated by Log % Full the Log Threshold event is
put in the event log. If this prompt is set to Yes and
either the RPS IP address or RPS Phone # are
programmed, then the control panel will attempt to
contact Unattended RPS as described in Section
2.6.3 Panel Initiated Unattended RPS on page 27.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Panel and Area Wide Parameters
RPS Call Back
Default:
Selection:
Yes
No
This function allows the control panel, after it verifies
the RPS passcode, to provide an additional level of
security by hanging up and dialing the RPS phone
number at the central station before allowing any
upload or download.
When using the RPS Call Back feature,
be sure to program the character "C" as
the last digit in the RPS phone number
when using DTMF Dialing.
RPS Line Monitor
Default:
Selection:
Yes
No
This program item enables a control panel that
shares a phone line with an answering machine to
communicate with RPS at the central station, even
though the answering machine answers the phone.
You must program Answer Armed or Answer
Disarmed. The control panel must be in the correct
armed state.
No
Yes or No
When the control panel hears the
correct RPS passcode, it hangs up
the phone, seizes the phone line,
then dials the programmed RPS
phone number (refer to the RPS Ph
prompt in this section). This ensures
that the control panel only
communicates with RPS units
connected to the programmed phone
number.
If the call is answered manually, the
call back must be initiated manually.
The RPS session starts immediately.
No call back is required. The control
panel can engage in RPS sessions
when called from any phone number
and a proper RPS passcode is
identified.
Yes
Yes or No
Allows the control panel to
communicate with RPS after the
answering machine answers the
phone.
Use No if the control panel does not
share the phone line with an
answering machine.
EN | 28