Bosch D7212GV3 Program Entry Manual page 103

D7212GV3 | Program Entry Guide | 5.0
UW# Sunday
Default: No
Selection: Yes or No
This prompt, and the next six day of the week
prompts, select the days of the week that the User
Group Window is active.
Refer to the W# Sunday prompt in
Section 5.1.1 Opening and Closing on
page 94 for more information about
programming this prompt.
UW# Monday
Default: No
Selection: Yes or No
UW# Tuesday
Default: No
Selection: Yes or No
UW# Wednesday
Default: No
Selection: Yes or No
UW# Thursday
Default: No
Selection: Yes or No
UW# Friday
Default: No
Selection: Yes or No
UW# Saturday
Default: No
Selection: Yes or No
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Schedules (Skeds)
UW# Group Enable
Default:
Selection:
This prompt must be programmed if this
User Group Window is assigned to a user
group.
Enter the time of day when the window starts.
Beginning at this time, users assigned to this
window's group can use their passcodes. The
window goes into effect at the beginning of the
minute. Make entries using a 24-hour clock (for
example, 7:00 AM is entered as 07:00, 2:45 PM is
entered as 14:45).
If the window must activate on the same day that you
program it, reboot the control panel to activate it
immediately.
UW# Group Disable
Default:
Selection:
This prompt must be programmed if this
User Group Window is assigned to a user
group.
Enter the time of day when the window ends. This
time marks the end of the period in which users
assigned to this window's group can use their
passcodes. The window stops at the end of the
minute. Make entries using a 24-hour clock (for
example, 7:00 AM is entered as 07:00, 2:45 PM is
entered as 14:45).
To disable the window, set the time to default (00:00).
Do not program a single window to cross the
midnight boundary. The window stop time must be
later than the window start time.
00:00
HH:MM (hours and minutes)
00:00
HH:MM (hours and minutes)
EN | 103