Administrative Features; The Embedded Web Server; Finding The Ip Address Of Your Printer - Xerox Phaser 6510 User Manual
Hide thumbs
Also See for Phaser 6510:
- User manual (229 pages) ,
- Quick use manual (5 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Features
Administrative Features
The Embedded Web Server
The Embedded Web Server is the administration and configuration software that is installed in the
printer. It allows you to configure and administer the printer from a Web browser.
The Embedded Web Server requires:
•
A TCP/IP connection between the printer and the network in Windows, Macintosh, UNIX, or Linux
environments.
•
TCP/IP and HTTP enabled in the printer.
•
A network-connected computer with a Web browser that supports JavaScript.
Accessing the Embedded Web Server
At your computer, open a Web browser. In the address field, type the IP address of the printer, then press
Enter or Return.
Finding the IP Address of Your Printer
To install the print driver for a network-connected printer, you need the IP address of your printer.
You also need the IP address to access the settings of your printer through the Embedded Web Server.
You can view the IP address of your printer on the control panel or on the Configuration Report.
Note:
Wait until the printer has been on for 2 minutes to view the TCP/IP address. If the TCP/IP
address is 0.0.0.0 or begins with 169, this indicates a network connectivity issue. For details, refer
to
Printer Does Not Print
To view the IP address of the printer on the Configuration Report:
At the printer control panel, press Menu.
1.
Navigate to Print Reports, then press OK.
2.
Navigate to Configuration, then press OK.
3.
To print the report, at the prompt, press OK.
4.
5.
To return the printer to Ready, press Menu.
The IP address information is located in the Communication Settings section of the Configuration
Report under IPv4 and IPv6.
To view the IP address of the printer on the control panel:
At the control panel, press Menu.
1.
Note:
To navigate through the menu, use the arrow buttons.
2.
Navigate to Admin Menu, then press OK.
3.
Navigate to Network/Port, then press OK.
4.
Navigate to TCP/IP Settings, then Press OK.
5.
Navigate to Ethernet, then press OK.
30
Xerox
Phaser
6510 Color Printer
®
®
User Guide
on page 125.
Advertisement
Table of Contents
Troubleshooting
