Xerox Phaser 6510 User Manual page 143

Symptom
• Page Margins Are
Inconsistent.
• The image is not centered on
the page or the margins are
not consistent.
Faded printouts with multiple
colors faded.
Only one color is faded.
Probable Causes
A paper registration adjustment
is needed.
The toner cartridges are not
Xerox toner cartridges.
®
The paper being used is outside
the recommended specification
range.
The paper type is heavier or
thicker than the paper type
selection.
The bias transfer voltage is not
properly adjusted for the paper
type.
The settings in the application
or print driver are incorrect.
The paper is damp.
The high-voltage supply is
defective.
Toner cartridge is empty or
damaged.
Solutions
Use the paper registration procedure to adjust
the image position on the page. For details,
refer to Adjusting Paper Registration
111.
Verify that the toner cartridges meet
specifications, and replace them if necessary.
Replace the paper with a recommended size
and type, and confirm that your control panel
and print driver settings are correct. For
details, refer to Supported Paper
• Ensure that the proper paper is loaded in
the paper tray.
• Choose a heavier paper type at the control
panel and in the print driver.
• Use a lighter paper or paper type.
Verify that the paper types set in the control
panel and the print driver match the paper
loaded in the tray.
Print the Demo Page. For details, refer to
Printing Reports on page 28. If the Demo
Page looks correct, the printer is printing
properly. Verify that the application and the
print driver selections are correct for your print
job.
Replace the paper.
For assistance, go to the Xerox
website at
www.xerox.com/office/6510support.
Check the condition of the toner cartridge and
replace it if necessary.
Xerox Phaser 6510 Color Printer
® ®
Troubleshooting
on page
on page 58.
Support
®
143
User Guide