Function Switches - Epson FX-80 User Manual

Front
Figure 1·11b.
(top view)
The factory sets it for normal paper (starting
from the back, that means to the third notch-
which gives about 1/ SOOth of an inch), but you
can adjust it for printing one original and up to
two copies. For thicker paper, move this lever
toward the front of the printer. To compensate
for faint print, move it toward the rear.
Function
switches
We're almost ready to start printing! Just a
few more important steps . . . like setting the
printer's internal switches. These are tiny
switches (inside the printer, of course) that con-
trol a number of printer functions (such as line-
feed adjustment, the paper-out buzzer, print
modes, etc.). In Appendix L, "Customizing the
FX-80," we'll show you how to play with the
different variations, but for now there are just a
few things we should say about them.
The switches are set at the factory and don't need to be touched
except for special uses and to solve problems with computer/printer
interfacing. You may need to answer one or two interface questions
right now. If you are using single-sheet paper, or if your computer
doesn't send line feeds to the printer, read on.
Note: Always turn the power
off
(with the switch on the left side of
the printer) before touching any internal switch!
The design of the FX-80 printer makes it easy to access the internal
switches. They are located under the upper-right vent (Figure 1-12a).
To remove the vent, you need a Phillip's-head screwdriver. Once the
top screw is removed, take the vent off by pressing down on the top
and pulling sideways. Insert a coin at the top of the vent and twist to
help the vent come off easily (Figure 1-12b).
14