Epson FX-80 User Manual page 299

Graphics Modes
CHR$(2"X) Fires pin X when sent as graphics data.
0(= X (= 7.
(ESC) "K"CHR$(n1)CHR$(n2);
Turns Single-Density Graphics Mode ON;
width
=
n1
+
256*n2
(ESC) "L"CHR$(n1)CHR$(n2);
Turns Double-Density Graphics Mode ON.
(ESC) "Y" CHR$(n1)CHR$(n2);
Turns High-Speed Double-Density Graphics
ON.
(ESC) "Z" CHR$(n1)CHR$(n2);
Turns Quadruple-Density Graphics Mode ON.
(ESC)"* "CHR$(n)CHR$(n1)CHR$(n2);
Selects Graphics Density n, where:
o
=
480 dots per line 4
=
640 dpl
1
=
960 dpl (same as (ESC)"L") 5
=
576 dpl (1-to-1 ratio)
2
=
960 dpl (same as (ESC) Ny") 6
=
720 dpl
3
=
1920 dpl (same as (ESC)"Z")
(ESC) """ CHR$(0)CHR$(n1)CHR$(n2);
Turns Single-Density Nine-Pin Graphics Mode
ON.
(ESC) """ CHR$(1)CHR$(n1)CHR$(n2);
Turns Double-Density Nine-Pin Graphics Mode
ON.
(ESC)" % "CHR$(n1)CHR$(n2)
Selects a character set: n1 selects ROM (0) or
RAM (1); n2 is
o.
(ESC)" & "CHR$(n)CHR$(c1)CHR$(c2)CHR$(A)CHR$(d1) ...
CHR$(d11). . . Defines characters c1 to c2 in RAM area; n is
o.
Each character requires an attribute byte (A),
followed by 11 data numbers (d1 to d11).
(ESC) " :" CHR$(n1)CHR$(n2)CHR$(n3)
(ESC) "11"
(ESC) "10"
(ESC) "6"
(ESC) "7"
268
Copies ROM characters to the user RAM area.
All numbers must be
o.
Enables printing of the symbols that are stored
in locations 0 - 31 and that are not used as con-
trol codes.
Disables printing of codes 0 - 31 as characters.
Enables printing of characters stored in locations
128 -159.
Causes codes 128 - 159 to print as control codes.