2.7 Adjusting Various Settings
2.7.1 DIP Switches
DIP switch 2 is available on the printer connector panel.
2.7.1.1 DIP switch 2 settings
•
To the left (as shown in the illustration above): when the USB interface is used.
•
To the right: when an interface other than the USB interface is used (ask your dealer for
instructions).
2.7.2 Memory Switches
The printer memory switches are software switches. They include Msw1, Msw2, Msw8,
customized values, and serial transmission conditions.
You can set the following using the memory switch setting utility (default: On for Msw2-1 only,
and off for all other settings).
Note:
You can change settings of the memory switches by any of the following methods:
•
Memory switch setting utility.
•
The printer's memory switch setting mode (items that can be changed are limited). See Section "2.7.3,
Memory Switch Setting Mode," (page 2-16) for the memory switch setting mode.
Ask your dealer how to obtain the memory switch setting utility.
Memory switch settings are stored in the NV memory and are not deleted even if the printer power is
turned off.
Rev. F
Figure 2-18 Connector panel
TM-J9000/J9100 Technical Reference Guide
DIP switch 2
Setup 2-13