Installation Overview - Harmar Mobility AL600 Installation And Owner's Manual

Preparation
Never attempt to pick up the lift from
the box, ground or on/of a vehicle
alone. Two people should work
WARNING
together to place this lift inside a
vehicle.
If only one person is available,
please follow the short disassembly
procedure on next page.
Overview – Installation Procedure
1. Install Wiring Harness. See page12. Installing
the wiring harness irst will ensure you have power
to the lift during installation. This allows access to
platform assembly outside the vehicle and at waist
level. (If you skip this step, use a 12V shop battery.)
2. Remove Seating & Determine Lift Placement.
Remove seating. For AL600 (page 14) this is
usually the third row; for AL690 (page 22),
second row. Determine mounting range by
climbing inside cargo area and closing access
door. Measure from inside the door threshold to
determine the lift's fully-stowed placement. For
the AL600, measure to 43"; for AL690, measure to
55." [Figure 10-1]
Look at the loor in the mounting area. If seat
removal reveals seat attachment points, or "dog
bones," you will not need to drill.
If no attachment points exist in the area, you
will need to drill two 3/8" holes approximately
1" to 10" from your measurement point. (See
installation section for details.)
10
SECTION 2 : INSTALLER
10"
AL600
55"
10"
Figure 10-1
© 2014 Harmar Mobility, LLC • All Rights Reserved
AL690
43"