Figure - Harmar Mobility AL600 Installation And Owner's Manual

8. With BA-02 installed in rear cargo area, examine
loor for area to install leg assembly. [Figure 19-1]
9. The AL600's leg will need to be mounted
between 32" and 42" from the internal surface of the
closed back door of the vehicle.
Examine the loor for additional seat attachment
points recessed into the loor. [Figure 19-2]
IMPORTANT:
Attachment Points MUST be FLUSH or LOWER than
the loor.
2nd ROW SEATING
CENTER
42"
32"

Figure 19-2

USE EXTREME CAUTION
Avoid Gas Tank, Fuel / Brake /
Electrical Lines
CAUTION
TEC0020 17Sep14 P/N: 630-00025 revA
SECTION 2 : INSTALLER
Figure 19-1
2nd ROW SEATING
42"
32"
Installation - AL600
With Folding 3rd Row Seating
10 A. If Seat Attachment Points ARE Available: See
Figure 19-3 for mounting diagram.
Mounting
Bracket
Figure 19-3
10 B. If Seat Attachment Points are NOT Available:
Look under vehicle in approximate area where Leg will
need to be mounted.
Drill a pilot hole irst, up from under the vehicle to
ensure nothing will be damaged. [Figure 19-3]
Find hole from inside vehicle and drill 3/8" hole down
through vehicle's loor. [Figure 19-4]
3/8"
Hex Head Bolt,
3/8-16 x 4.00"L
Fully Threaded
Mounting Bracket
Mounting
Bracket
PILOT
HOLE
Hex Head Bolt,
1/2-13 x 4.00"L
Fully Threaded
AL600 & AL690 Hybrid Installation & Owner's Manual 2014
3/8 - 16 Nyloc Nuts
3/8 Flat Washer
Mounting Bracket
3/8 - 16
J-HOOK
Hex Head Bolt,
1/2-13 x 4.00"L
Fully Threaded
3/8"
3/8 Flat
Washer
Installation
Washers
3/8 - 16
PILOT
HOLE
Nyloc Nuts
Figure 19-4
19