Harmar Mobility AL600 Installation And Owner's Manual page 28

Chair / Scooter Preparation
ANCHOR U-BOLTS
Use U-Bolts with Power Chairs or Scooter that do
not have a center seat post.
For power chairs or scooters without a center seat
post, the seat is normally attached to a tubular frame.
Install the U-bolts, two on each side, to the frame as
shown. [Figure 28-1]
Ensure that the loop extends to the outside of the
chair so the user can attach the strap hooks.
[Figure 28-2]
U-bolt placement will difer among models and
manufacturers. Place the U-bolts towards the center
of the seat if possible. Due to diferent seat types, you
may be forced to install the U-bolts more towards the
front or rear of the seat, but we recommend attaching
as close as possible to the center of the seat.
28
SECTION 2 : INSTALLER
ALA580
U-BOLT HARDWARE KIT
KIT CONTAINS
4 - 1/4-20 x 3-1/4" U-BOLTS
8 - U-BOLT BACKING PLATES
16 - SPLIT LOCK WASHERS
16 - 1/4-20 NUTS
SEAT
POST
SEAT
POST
SEAT
POST
:
© 2014 Harmar Mobility, LLC • All Rights Reserved
SEAT
POST
Figure 28-1
Figure 28-2