Table of Contents
Advertisement
Preparation
Installation Overview
Never attempt to pick up the lift from the box, ground or on/off a
vehicle alone.
WARNING
Two people should work together to place this lift inside a vehicle.
If only one person is available, please follow the short disassembly
procedure below.
Overview of Recommended Installation Procedure
1. Choose a Location.
base and leg extensions in the
far corner of the truck bed.
Driver's Side
Base Required
2. Install Vehicle Wiring Harness.
aiding in the installation. [See page 13]
3. Install Lift Components.
Install power base assembly
onto base mounted to truck
bed. [See pages 19 ]
Driver's Side
Base Shown
12
SECTION 2 : INSTALLER
Examine under the truck where
Place
three to five holes will need to
be drilled. (Number of holes
depend on payload)
Passenger Side
Base Required
Installing the wiring harness first will allow powered movement of the lift,
Install vertical post so that
bottom horizontal bar just clears
truck side wall.
| www.harmar.com | 800-833-0478
FR A M E
Install lifting arm using bolts
provided.
F R
A
M
E
Advertisement
Table of Contents
