Section 1: Owner; Operating Your Lift; Al600 Operation - Harmar Mobility AL600 Installation And Owner's Manual

LOADING & SECURING YOUR CHAIR
Lower the Lift Platform. Using your remote control, lower the
lift platform until it reaches the ground and becomes level. Do
NOT over-lower to the point where the vehicle begins to rise
or the platform rises with the "DOWN" button pressed. This will
damage the lift or cause the lifting system to back drive.
1. Drive Chair/Scooter onto Platform. Set your chair or
scooter's speed control to slow speed to maneuver easily
onto the platform. [Figure 3-1] You can drive onto the
platform from either side.
2. Secure the Chair. Each corner of the AL600
platform has a restraint attached, with a hook on
the end. Place each hook in either the anchor
plate slot or in each U-bolt. [Figure 3-2]
Pull the loose end of each restraint tight. To
release, simply press the release tab and remove
the hooks. [Figure 3-3]
3. Fold Seat Backs. If your chair has a folding seat back,
you may want to place it in the down position for easier
clearance when loading the chair into the vehicle.
Depending on the size of your chair, you may need to
remove the headrest as well.
4. Raise the Chair. Double-check that the chair is secured
properly on the platform. While holding the hand control,
stand to the side and away from the lift. Press the "UP"
button. [Figure 3-4]
The platform will rise and retract into the vehicle. When the
platform stops retracting release the button. The platform will
automatically lock itself into travel position. Close the door
slowly, making sure that no part of the chair or other objects in
the cargo area contact the door.
TEC0020 17Sep14 P/N: 630-00025 revA
SECTION 1 : OWNER
Figure 3-2
AL600 & AL690 Hybrid Installation & Owner's Manual 2014

AL600 Operation

S L O W
Figure 3-1
PUSH to
RELEASE
PULL to
TIGHTEN
Figure 3-4
Figure 3-3
3