Harmar Mobility AL600 Installation And Owner's Manual page 23

3B. If Seat Attachment Points are NOT Available:
Look under vehicle in approximate area where Leg will
need to be mounted. [Figure 23-1]
3/8 Flat
Washer
Hex Head Bolt,
1/2-13 x 4.00"L
Fully Threaded
3/8-16
Nyloc Nut
Look under vehicle in approximate area where leg
will need to be mounted.
Drill a pilot hole irst, up from under
the vehicle to ensure nothing will be
damaged.
Find hole from inside vehicle and drill
3/8" hole down through vehicle's loor.
USE EXTREME CAUTION
Avoid Gas Tank, Fuel / Brake /
Electrical Lines
CAUTION
False loor support available
when applicable for vehicles
with Stow & Go seating. (2nd
row seats must be removed)
TEC0020 17Sep14 P/N: 630-00025 revA
SECTION 2 : INSTALLER
Hex Head Bolt,
3/8-16 x 4.00"L
Fully Threaded
Mounting
Bracket
Installation
Washer
Figure 23-1
Installation - AL690
4. Installing the Rear Leg. The AL690's rear leg will be
installed approximately 24" to 36" from the front leg.
[Figure 23-2]
The uprights on both legs must be in line and square.
Verify by measuring corner to corner. Distance should
be identical. [Figure 23-3]
R E A R L
E G
I N
F R O N T
L E G - L
I N
BE SURE
" X "
REAR LEG
=
FRONT LEG
" X "
AL600 & AL690 Hybrid Installation & Owner's Manual 2014
Figure 23-2
E
24-36"
Figure 23-3
23