Page 2
THANK YOU From all of us at Harmar, thank you for placing your trust in our products and allowing us to be a part of your journey. For more than 20 years we have been committed to building products that help you maintain independence. With a drive to empower people to live as they choose, Harmar Lifts Lives.
AL600 / AL600HD: SECTION 1 SAFETY SECTION 1 SAFETY SAFETY DEFINITIONS Consider the following general information when using your lift. Specifics may vary based on your chair model and lift combination. This safety alert symbol appears with safety statements. It means attention,...
Page 5
AL600 / AL600HD: SECTION 1 SAFETY WARNING This lift is NOT meant for human transport. The chair or scooter MUST be unoccupied before operating the lift. Each lift is designed to transport a specific mobility device only. DO NOT attempt...
SECTION 2 INTRODUCTION DEVICE NAME: AL600 / AL600HD HYBRID VEHICLE LIFT Indications of Use: The intended use of the AL600 / AL600HD is to lift, secure and transport an unoccupied mobility device for patients or mobility- impaired persons. READ AND UNDERSTAND...
AL600 / AL600HD: SECTION 3 OPERATION SECTION 3 OPERATION LOADING AND SECURING device. This is usually under the drive wheels, motor(s), and batteries. Always drive onto the YOUR MOBILITY DEVICE platform with the heaviest portion closest to the lifting tower. If loading a scooter and the...
Page 8
HOLD-DOWN ARM RETENTION STRAPS 1. If applicable, the hold-down arm may be rotated Each corner of the AL600 platform has a out of the way. Pull the T-handle and rotate the restraint attached, with a hook on the end. hold-down arm to the desired position. Release Place each hook in either the anchor plate slot, the T-handle to lock in place.
Page 9
AL600 / AL600HD: SECTION 3 OPERATION TURN TO TIGHTEN PUSH TO RELEASE Figure 3-7 If your chair has a folding seatback, you may PUSH to RELEASE want to place it in the down position for easier PULL to clearance when loading the chair into the TIGHTEN vehicle.
AL600 / AL600HD: SECTION 3 OPERATION Use the hand-held pendant controller or If you plan on leaving the lift out / down for an optional wireless key-fob controller, to raise extended period of time and wish to turn off the...
Page 11
AL600 / AL600HD: SECTION 4 MAINTENANCE If your lift has the optional Q’Straint retractors, press and hold the lever to release the straps and unhook them from the anchor plates, U-bolt, or tie-down loops. If your lift is secured with the securement...
AL600 / AL600HD: SECTION 4 MAINTENACE SECTION 4 SAFETY & MAINTENANCE Except as described elsewhere in this manual, • Use a good black enamel or lacquer to inhibit maintenance must be performed only by qualified rust. You may need to do this more frequently technicians.
AL600 / AL600HD: SECTION 4 MAINTENANCE MAINTENANCE/SERVICE RECORD Type of Service (check all that apply) Notes, Nature of Service/Accident, Parts Replaced, Date Time Technician Warranty Check Repair Maint. Accident Owner’s Manual AL600 / AL600HD: 19MAR2021 | MKT-000174 REV A...
PRODUCTS COVERED: AL600 SERIES MODELS Your lift came with a separate warranty page on Harmar Mobility warrants to the original purchaser of the page 15. You must return this page in within ten vehicle lift manufactured by Harmar to be free of defects (10) days of installation to register your lift.
Page 15
AL600 / AL600HD: SECTION 5 WARRANTY PLEASE FILL OUT ALL FIELDS AND RETURN WITHIN TEN (10) DAYS OF PRODUCT INSTALLATION. Fax completed form to 1-866-234-5680 or mail to: Harmar, ATTN Warranty Department, 1500 Independence Blvd., Suite 220, Sarasota Florida 34234.