Table of Contents
Advertisement
Chapter 3 Setup
2.
BIOS Setup Utility (SETUP)
This section describes how to configure Basic Input Output System (BIOS).
2.1
Overview
BIOS Setup Utility (SETUP) is a utility to configure basic hardware settings. This utility is installed in the server
as standard.
Factory settings of BIOS are set with optimal settings. Usually, you do not need to run SETUP. Use only
when the case applies to any of cases described in Chapter 3 (2.4 Cases That Require Configuration).
2.2
Starting SETUP Utility
Run POST following Chapter 3 (1.1.1 POST sequence).
After a while, the following message will be displayed on the lower left of the screen. The on-screen message
depends on your environment.
Press <Del> to enter setup, <F10> Display Boot Menu, <F12> Force Network Boot
If you press the <Del> key, SETUP starts upon completion of POST, and the Main menu is displayed.
Password
If you have set a password, a message prompt you to enter password will be displayed.
Enter password［
If you entered an incorrect password three times, operation stops and you cannot operate further.
Turn off the power and retry.
Saving changes
To save changes and exit, choose Save & Exit and then Save Changes and Reset.
Choose Save & Exit
Tips
If the boot mode is the legacy BIOS mode, SETUP starts up if the <Del> key is pressed
when the optional ROM message appears.
Discard Changes and Reset when finishing the utility without saving.
and then
Tips
• If you want to restore the setting to default values, select Save & Exit and then Restore
Defaults.
• Some default values are different from the factory settings.
Express5800/D120h User's Guide
］
2. BIOS Setup Utility (SETUP)
105
Advertisement
Table of Contents
