Cisco 340 Series Configuration Manual page 86

rdg
rdg
To configure the Reverse Direction Grant (RDG) when an access point functions in the 802.11n mode,
use the rdg command in the WiFi AP interface configuration mode.
Note This command applies to the 802.11n mode or the 802.11n mixed mode.
Syntax Description on
off
Command Default RDG is disabled.
Command Modes WiFi AP interface configuration
Usage Guidelines When RDG is enabled, a transmitter that has reserved the channel transmission opportunity allows the
receiver to send packets in the reserved direction. When RDG is disabled, packets can be transmitted
only in one direction during the channel transmission opportunity reservation.
Enable RDG for better throughput performance of 802.11n traffic.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-68
rdg {on | off}
Enables RDG.
Disables RDG.
Chapter 2 Configuring Local CLI - CLISH
OL-29491-01