Cisco 340 Series Configuration Manual page 47

Chapter 2 Configuring Local CLI - CLISH
monitor
To enable or disable the monitor type of HDMI or VGA, use the monitor command in the system
configuration mode.
Syntax Description type
hdmi
vga
on
off
Command Modes
System configuration
OL-29491-01
monitor type {hdmi | vga} {on | off}
Sets the monitor type.
Sets the monitor type to HDMI.
Sets the monitor type to VGA.
Enables the monitor.
Disables the monitor.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
monitor
2-29