Configuring Syslog - Cisco 340 Series Configuration Manual

Chapter 3 Configuring the Web GUI
Figure 3-8

Configuring Syslog

Click Syslog in the left pane to configure the setting of syslog.
Enter the path in which you want to store the syslog in the Path field. The system will automatically
Step 1
check if the path that you enter is valid.
Choose the level of syslog from the Level drop-down list:
Step 2
•
•
•
•
•
•
•
•
•
In the Size field, enter the size of the syslog in the left column and choose the unit of the log size from
Step 3
the right drop-down list.
Size has three units: KB, MB, and GB. The maximum log size is 50 MB, and the default size is 10 MB.
If the value you provide exceeds 50 MB, the change fails and the original size is retained. You cannot
use GB as the unit. If you choose KB or MB, the log size value cannot be 0.
Step 4 Click Apply to save the changes and Reset to restore the default values.
OL-29491-01
Date and Time Information
Debug
Info
Notice
Warning
Error
Critical
Alert
Emergency
* (All of above)
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
System Configuration
3-7