System Configuration Mode Commands - Cisco 340 Series Configuration Manual

show

System Configuration Mode Commands

This section contains system configuration mode commands.
commands perform.
Table 2-3
Command
auto-login
bluetooth
clock
display
do
exit
hdmi
hostname
interface
language support
log
monitor
ntp
proxy-server
ssh
ssid
vga
wifi-mode
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-18
System Configuration Mode Commands
Function
Enables or disables auto login to the system.
Enables or disables bluetooth on the device.
Configures the time zone.
Configures the relation between HDMI and VGA when two
monitors are connected.
Executes user EXEC or privileged EXEC commands from the
global configuration mode or other configuration modes or
submodes.
Exits the system configuration mode.
Configures HDMI resolution and rotation.
Configures the hostname of the device.
Enters the Ethernet interface configuration mode to configure the
Gigabit Ethernet interface, or enters the WiFi AP interface
configuration mode to configure the wireless interface.
Configures the language of the device.
Configures the log size.
Enables or disables HDMI or VGA.
Configures the NTP server that is used by the device.
Configures the proxy server.
Configures the SSH users.
Configures the SSID name and enters the SSID configuration mode
to configure the security settings for the access point.
Configures VGA resolution and rotation.
Sets the WiFi mode.
Chapter 2 Configuring Local CLI - CLISH
Table 2-3 describes the functions these
OL-29491-01