Get Igmp Sn Enable - Cisco 340 Series Configuration Manual

Wi-Fi Client Information
Parameter Restrictions
The valid parameter is 0 or 1.

Get IGMP SN Enable

Example: get IGMP SN Enable
Request
curl -k -X GET -H 'password: cisco123!' https://localhost/api/2.0/wifi/ap/igmpSnEnable
Reply
{"igmpSnEnable":"0","success":"true","getAt":"2013-05-22 08:06:44"}
Wi-Fi Client Information
For the commands in this section, assume that the Wi-Fi client IP address is 10.140.44.147.
Note
Get AP List
Example: get ap list
Request
curl -k -X GET -H 'password: cisco123!' https://localhost/api/2.0/wifi/client/list/ap
Reply
{"ap":"BSSID / FLAG / FREQUENCY / STRENGTH / SSID / ACTIVE\nD8:24:BD:76:8D:A7
2437
\n10:BD:18:AA:02:48
29
Get Connection List
Example: get connection list
Request
curl -k -X GET -H 'password: cisco123!'
https://localhost/api/2.0/wifi/client/list/connection
Reply
{"connection":"blizzard","success":"true","getAt":"2013-04-24 13:28:56"}
Get WiFi Client AP Flags
Example: get WiFi client ap flags, assuming that the ssid is blizzard
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
4-36
14 cisco-8DA5 \n0C:D9:96:76:74:5F
[ 0,188]
sbbu-alpha","success":"true","getAt":"2013-04-24 13:30:17"}
[ 0,288]
2437 10 ciscosb1 \n64:AE:0C:F0:BB:D0
Chapter 4 Configuring HTTP API
5805 22 blizzard
[14C,14C]
[ 0, 0]
5200
OL-29491-01