Cisco 340 Series Configuration Manual page 85

Chapter 2 Configuring Local CLI - CLISH
packet aggregation
To configure Aggregate MAC Service Data Unit (A-MSDU) packet aggregation when an access point
functions in the 802.11n mode, use the packet aggregation command in the WiFi AP interface
configuration mode.
This command applies to the 802.11n mode or the 802.11n mixed mode.
Note
Syntax Description on
off
Command Default
Packet aggregation is off.
Command Modes WiFi AP interface configuration
Usage Guidelines Enable packet aggregration if network traffic consists primarily of data.
Disable packet aggregration if network traffic consists primarily of voice, video, or other multimedia
traffic.
OL-29491-01
packet aggregation {on | off}
Enables packet aggregation.
Disables packet aggregation.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
packet aggregation
2-67