Cisco 340 Series Configuration Manual page 19

Configuring Local CLI - CLISH
This chapter contains the following sections:
•
•
Configuration Guidelines
You can configure the Cisco Edge 340 Series in CLISH, which is used for the local CLI configuration.
The CLI uses only those commands that are specific to the Cisco Edge 340 Series. Although the syntax
is similar to the Cisco IOS CLI, these commands are incompatible with Cisco IOS commands.
You can use CLISH in two modes:
•
•
Use the CLI to configure these device settings:
•
•
•
•
Follow these configuration guidelines when using CLISH:
•
•
•
OL-29491-01
Configuration Guidelines
Command Reference
User mode—When you log in to the Cisco Edge 340 Series as an ordinary user, you enter the user
mode. To enter the privileged mode, enter the enable command and then enter the password of the
root user.
Global (privileged) mode—When you log in to the Cisco Edge 340 Series as root user, you enter the
global mode directly and do not have to enter the enable command.
Basic device settings—Hostname, MAC address, bluetooth settings, password, Network Time
Protocol (NTP) server, and device language
Ethernet interface settings—Status, speed, and quality of service (QoS)
Wireless interface settings—Status, radio, wireless mode, channel, wireless separation,
transmission power, Wi-Fi Multimedia (WMM), and advanced wireless settings
Service Set Identifier (SSID) security settings—Broadcast, authentication, and encryption
Enter ssh username@ip-address or ssh root@ip-address in the command prompt in your PC, and
enter the password in the welcome screen. Enter the mgtcmd command to start the CLISH process.
If you log in as an ordinary user, enter the enable command and the password of the root user to
switch to the global mode.
Start a Cisco Edge configuration with the configure terminal global command. End the Cisco Edge
configuration file with the exit global command.
C H A P T E R
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2
2-1