Cisco 340 Series Configuration Manual page 64

speed
WiFi AP Interface Configuration Mode Commands
This section contains WiFi AP interface configuration mode commands.
functions these commands perform.
Table 2-5
Command
aggregation-msdu
ap-isolation
apsd
auto-block
ba-decline
beacon-interval
bg-protection
channel bandwidth
channel number
data-beacon-rate
do
exit
extension channel
frag-threshold
guard-interval
igmp-snoop
mcs
multicast-mcs
multicast-phy-mode
operating-mode
packet aggregation
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-46
WiFi AP Interface Configuration Mode Commands
Function
Enables or disables aggregation MAC Service Data Unit (MSDU).
Configures wireless separation for clients that are connected to the
same SSID.
Configures Wi-Fi Multimedia (WMM) power save mode for an
access point.
Enables or disables auto block.
Enables or disables to decline a ba request.
Configures the beacon interval for an access point.
Configures the CTS-to-self protection for an access point.
Configures the channel width when the access point functions in the
802.11n mode or the 802.11n mixed mode.
Configures the channel number (which sets the frequency) for an
access point.
Configures the Delivery Traffic Indication Message (DTIM)
interval for an access point.
Executes user configuration or global configuration commands
from the global configuration mode or other configuration modes.
Exits the WiFi AP interface configuration mode.
Configures the control-side band that is used for the extension or
secondary channel when the access point functions in the 802.11n
mode or the 802.11n mixed mode.
Configures the frag threshold.
Configures the period between packets when an access point
functions in the 802.11n mode or the 802.11n mixed mode.
Enables or disables Internet Group Management Protocol (IGMP)
snooping.
Configures the high throughput Modulation and Coding Schemes
(MCS) rate when the access point functions in 802.11n mode or
802.11n mixed mode.
Configures the high throughput MCS rate on multicast frames.
Configures PHY mode on multicast frames.
Configures greenfield or mixed mode when the access point
functions in the 802.11n mode.
Configures Aggregate MAC Service Data Unit (A-MSDU) packet
aggregation when an access point functions in the 802.11n mode or
the 802.11n mixed mode.
Chapter 2 Configuring Local CLI - CLISH
Table 2-5 describes the
OL-29491-01