Cisco 340 Series Configuration Manual page 101

Chapter 2 Configuring Local CLI - CLISH
radius-server
To configure the related information of a RADIUS server, use the radius-server in the SSID
configuration mode.
Syntax Description hostname
auth-port
port_number
key
secret
Command Default The default value for port_number is 1812.
The default value for secret is NULL.
Command Modes
SSID configuration
Examples This example shows how to configure the related information of a RADIUS server:
radius-server 192.168.1.1 auth-port 1812 key pass1234
OL-29491-01
radius-server hostname [auth-port port_number] [key secret]
Hostname or IP address of the RADIUS server.
Specifies the authentication port number of the RADIUS server.
Authentication port number of the RADIUS server. The range is from 0 to
65535. The default is 1812.
Specifies the password of the authentication service on the RADIUS server.
Password of the authentication service on the RADIUS server.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
radius-server
2-83