Cisco 340 Series Configuration Manual page 49
Hide thumbs
Also See for 340 Series:
- Installation and configuration manual (132 pages) ,
- Hardware installation manual (80 pages) ,
- Quick start manual (16 pages)
Table of Contents
Advertisement
Chapter 2
Configuring Local CLI - CLISH
ntp
To configure the Network Time Protocol (NTP) server that is used by the Cisco Edge 340 Series device,
use the ntp command in the system configuration mode.
Syntax Description
refresh
on
off
server ip_address
Command Modes
System configuration
OL-29491-01
ntp {refresh {on | off} | server ip_address}
Configures auto sync of the NTP server.
Enables auto sync of the NTP server.
Disables auto sync of the NTP server.
Configures the IP address of the NTP server
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
ntp
2-31
Advertisement
Table of Contents
