Cisco 340 Series Configuration Manual page 55

Chapter 2 Configuring Local CLI - CLISH
Ethernet Interface Configuration Mode Commands
This section contains Ethernet interface configuration mode commands.
functions these commands perform.
Table 2-4
Command
do
duplex
exit
ip address
ip default-gateway
ip name-server
ipv6 address
ipv6 default-gateway
ipv6 name-server
speed
OL-29491-01
Ethernet Interface Configuration Mode Commands
Function
Executes user configuration or global configuration commands
from the global configuration mode or other configuration modes.
Configures the duplex mode for the Gigabit Ethernet (GE) interface.
Exits the Ethernet interface configuration mode.
Configures the IP address of an interface.
Configures the default gateway.
Configures the DNS server.
Configures the IPv6 address of an interface.
Configures the IPv6 default gateway.
Configures the IPv6 DNS server.
Configures the speed for the GE interface.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
wifi-mode
Table 2-4 describes the
2-37