Cisco 340 Series Configuration Manual page 67

Chapter 2 Configuring Local CLI - CLISH
ap-isolation
To configure wireless separation for clients that are connected to the same Service Set Identifier (SSID),
use the ap-isolation command in the WiFi AP interface configuration mode.
Syntax Description on
off
Command Default
Wireless separation is disabled.
Related Commands
WiFi AP interface configuration
OL-29491-01
ap-isolation {on | off}
Enables wireless separation. Wireless clients that are connected to the same
SSID are prevented from communicating with each other.
Disables wireless separation. Wireless clients that are connected to the same
SSID can communicate with each other.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
ap-isolation
2-49