Safety Systems; Overview; Overload Protection - Bosch MUM XL...GB Instruction Manual

en
Safety systems

Safety systems

Start lock-out
See "Overview of the operating positions"
table.
In position 1 the appliance cannot be
switched on. The appliance can be switched
on in position 2-4 only:
■ when the bowl has been inserted and
rotated as far as possible
or
■ the tool drive cover (7) has been
attached.
In position 5 the appliance can only be
switched on when the tool drive cover (7)
has been attached. The blender must be
screwed in all the way.
In position 6 the appliance cannot be
switched on unless the mincer and adapter
have been attached correctly (see mincer
operating instructions).
Restart lock-out
If the power is interrupted, the appliance
remains switched on but the motor does
not start running again when the power is
restored.
To restart the appliance, turn the rotary
switch (3) to 0/off, then switch on the
required setting.

Overload protection

If the motor switches itself off while the appli-
ance is being used, the overload protection
feature has been activated.
Possible causes:
– very large amounts of ingredients,
– appliance operated too long.
If a safety system is activated, see
"Troubleshooting".
The operating instructions describe several
models, see also overview of models
(Fig. J).
6

Overview

Please fold out the illustrated pages.
Figure A:
Base unit
1 Release button
2 Multi-function arm
"Easy Armlift" – supports the simple and
effortless operation of the multi-function
arm (see "Operating positions").
3 Rotary switch
When the appliance has been switched
off (0/off position), it automatically runs
to the optimum position for changing the
tools (tool change position). This position
also facilitates filling the bowl with ingre-
dients, as no ingredients can stick to the
tools ("Easy fill" position).
0/off = Stop
M = Instantaneous switching at
maximum speed, hold switch for required
blendingn duration.
Settings 1-7, Operating speed:
1 = low speed – slow,
7 = high speed – fast.
4 Drive cover
To remove the drive cover, press on the
rear area and remove cover.
5 Drive for
– continuous-feed shredder*
– citrus press*
– grain mill *.
When not in use, attach the drive cover.
6 Drive for tools
(stirrer, whisk, kneading hook)
and mincer*
7 Drive cover
8 Drive for blender
When not in use, attach the blender drive
cover.
9 Blender drive cover
10 Cord store
Cord store or automatic cord winder
(depending on model)
Bowl with accessories
11 Stainless steel stirring bowl
12 Lid
13 Funnel