Data Logger - Ecom EN2 Operating Instructions Manual

RDT <-> PC !:
Load data:
Enables the data import from e.g. rbr software (available on our website
„www.rbr.de"). See chapter „Technical Data" for data format information
(please observe the transfer options of your software!).
Proceed as follows:
-Connect ecom-J2KN and PC via USB cable.
-Select "Load data" and confirm with <Enter>.
-Answer the displayed question with YES (<F1>).
-Decide if the data recorded can be cancelled
(<F1> for YES / <F4> for NO).
-Start the data transfer on your PC.
Send data:
With this function the data records completed with measurement values
can be transferred to the PC programme (procedure similar to chapter
„Load data").

Data logger:

Here a Data logger record ("Data logger" and key <OK> / on top right
on the display appears the disk symbol) can be started or finished (just
available when using the multi media card). For each recording one file
will be written on the card. The files will be numbered consecutively (J2KDL-
00.csv, J2KDL-01.csv and so on) and can be transferred to PC with a
card reader. The length of a dataset is 500 byte which means that on a
32 MB card 64000 measurements could be recorded.
In addition to data logger recordings the data could be transferred online
(with USB cable at 1200 Baud / Protocol DAS) to the software "DASNT".
The software is available free of charge from the rbr website.
Save to MMC (min. 1 second / max. 255 seconds):
Adjustment of the interval time for data logger recordings.
ecom-EN2 Page 29