Ecom EN2 Operating Instructions Manual page 39

Probe and tubing
Depending on the frequency of use, probe and tubing should be regularly
cleaned in order to release particle deposits and to prevent early wearing
due to corrosion.
- Release the connections at the instrument and at the probe grip
to free the tubing.
- Clean it (flow warm water in then dry respectively blow water drops out.
- Slightly grease the O-rings of the tubing connections from time to
time with acid-free grease.
Change printer paper roll
- Release the printer cover (press lock downwards).
- If necessary, extract the paper rest out of the printer. Hereto select
"Adjustments"/"Paper feed"/<Enter>).
- Remove the plastics tube of the previous roll.
- Insert the paper end in the slot under the transport roll (paper roll inner
side facing you while inserting the paper).
- Convey approx. 3 cm paper thru the printer ("Adjustments"/"Paper
feed"/<Enter>).
- Lay the paper roll in the corresponding hollow.
- Insert the paper thru the slot of the printer compartment cover
and close the latest.
Lock printer
cover
ecom-EN2 Page 39