Table of Contents
Advertisement
XO – Save Start
After this command is received, all subsequent commands will be stored in a
file in flash memory until the save terminate command (XP) is received. The
ID in this command specifies the file name. The files can later be loaded from
flash and executed as host data using the XQ command.
XP – Save Terminate
This command terminates the saving of data into a file in flash memory.
Saving into a file is started through the XO command.
XQ – Saved Data Call
This command loads a saved file from flash memory and executes it as host
data. Files are saved in flash memory using the XO and XP commands.
XR – Clear Area
This command clears or inverts a specified area in the drawing space. The
area coordinates are specified in 1/10 mm units.
XS – Issue
This command prints the label. Several parameters are provided which
configure the print settings: speed, sensor type, and copy-count.
i / iN – Issue
This legacy command prints the label. If N is provided, a copy count can be
specified.
19
Advertisement
Table of Contents
