Table of Contents
Advertisement
Chapter
2
RC / rC – Bitmap Font Data
This command supplies data for a bitmap font field configured by the PC
command. The data will replace the data supplied with the PC command or
with a preceding RC command.
RV / rV – Outline Font Data
This command supplies data for an outline font field configured by the PV
command. The data will replace the data supplied with the PV command or
with a preceding RV command.
SG – Graphic
This command is used to draw graphics. The location and size of the image
are specified in 1/10 mm units. Six modes are supported: Nibble mode
(Overwrite), Hex mode (Overwrite), Bitmap (.BMP) mode, Topix Compression
mode, Nibble mode (OR), and Hex mode (OR).
NOTE: A configuration setting (Scale Image) is provided to scale the images
SG0 / SG1 – Graphic
These are two legacy commands that were supported on older TEC models.
The commands are used to draw graphics. The location of the image is
specified in 1/10 mm units. The size is specified in multiples of 8 dots. For
example, a width of 3 and a height of 2 will draw an image of 24 x 16 dots.
T – Feed
This command feeds one label of the size set by the D command. Parameters
specify the feed speed, sensor to be used, etc.
U1 / U2 – Forward/Reverse Feed
This command moves the media forward (U1) or reverse (U2) over the
specified distance in 1/10 mm units.
NOTE: For 6700-M40 printers, the Backward Feed is limited to a maximum of
16
drawn with this command in order to exactly match the size of images
on TEC printers (Scaling 306 > 300 dpi).
1 inch. The valid range for this parameter on the 6700-M40 is
0030 to 0254 (in 0.1 mm units).
Advertisement
Table of Contents
