InfoPrint 6700 Series Programmer's Reference Manual page 32

Appendix B
Serial And Ethernet Interface
Table 5. Status Response in Save Mode (saving writable characters to flash)
LCD Message
Save mode Saving downloadable characters or
labels
Flash write Error in writing to flash
error
Format error Error in erasing flash
Flash memory Insufficient capacity of the flash memory
full
On line Command error found during analyzing
Communication Parity, overrun, framing error occurred
error during serial comm.
NOTE: This status will not be sent out if the serial interface is used. Other than on TEC printers,
InfoPrint printers will go offline when an error occurs, and therefore prevent the host
computer from sending status request commands.
32
Printer Status
Status
Auto Status
Request
Transmission
Command
X 55
50 50
See Note on
page 32.
51 51
See Note on
page 32.
54 54
See Note on
page 32.
06 06
See Note on
page 32.
07 07
See Note on
page 32.