Maintenance: Change Usernames & Passwords; Maintenance: Usernames & Passwords > Change Usernames And Passwords - VBrick 6000 series Admin Manual

Write Configuration Data to Device
To write configuration parameters to the VBrick from an .xml file
1. Click the
Browse
appliance.
2. Click on the
parameters will be saved to Flash memory and the appliance will reboot. In the event of
a validation error, a message will appear on the screen. Click on
messages that might have caused the validation failure. The error list is not generated for
all types of write configuration failures so you may need to locate the error(s) manually
by clicking through the IWS pages in Edit mode and looking for error messages
highlighted in red.
To create a configuration file
1. Read the configuration from the VBrick and save as an .xml file. See Read Configuration
Data from Device above.
2. Use any text editor, preferably an .xml editor to make changes to the file. You can change
the "values" field as well as delete objects as necessary. Make sure the right data types are
used. For example if a parameter takes integer values, do not enter a string. Also IP
Address parameters must have the right IP syntax. Enter "0.0.0.0" to enter a null IP
address. Blanks and null strings are not valid IP Addresses.
Maintenance: Change Usernames & Passwords
Maintenance: Usernames & Passwords > Change
Usernames and Passwords
This page lets an Administrator change usernames and passwords for security purposes.
VBrick MPEG-4 Appliance Admin Guide
button and navigate to the configuration file you want to write to the
button to write the selected file to the VBrick. The configuration
Write
Maintenance
to view error
Errors
89