VBrick 6000 series Admin Manual page 78

Session Origin
Program Name
Program Information
Target Latency
Connection Duration
Connection Protocol
Video
Source Video
Resolution
Source Pixel Aspect
Ratio
Displayed Video
Resolution
Measured Video Frame
Rate
Target Video Bit Rate
Measured Video Bit
Rate
Video Frames Decoded The number of frames decoded for the video stream being
Bad Video Frames
Key Frames Decoded
68
Derived from SDP file. The IP address, VBrick Host Name, or
DNS name of the encoder. If the
, the slot number is appended.
Address or Hostname
Derived from SDP file. The program name for the stream this
decoder is receiving.
The program information in the SDP file for the stream this
decoder is receiving. Default is "VBrick Streaming Video."
Defines the decoder latency which the software is attempting to
maintain. A primary factor in determining the target latency is the
configured
Time in Jitter Queue
RTP on page 22.) The entered value may be increased by the
decoder software if it determines that an unacceptable viewing
experience will result from maintaining that target latency. Any of
the following factors may result in an increased target latency: a
metered VBrick encoder source, difficulty in synchronizing audio
and video, or excessive jitter of the encoded stream.
Length of time the current connection has been active.
The protocol being used for this connection: Multicast, Unicast,
or RTSP.
The source video resolution for the video stream this decoder is
receiving.
The source pixel aspect ratio for the video stream which this
decoder is receiving. Possible values are PAL, NTSC, Square, 4:3,
and 16:9.
The video resolution for the video stream, after scaling, being
displayed by this decoder.
The video frame rate for the video stream being displayed by this
decoder.
The estimated video bit rate from the encoder for the video
stream this decoder is receiving. If the video stream is metered by
the encoder, there will be an indication (metered, jittered, or
unspecified) appended to the end of the bit rate.
The measured bit rate for the video stream being displayed by this
decoder.
displayed by this decoder.
The number of video frames that could not be decoded.
The number of key frames decoded.
is
Connection Mode VBrick IP
(see Configuration: Decoder >
© 2009 VBrick Systems, Inc.