VBrick 6000 series Admin Manual page 91

Intermediate hops are discovered by launching probe packets with a small TTL and then
listening for an ICMP Time Exceeded reply from a gateway. Use
to run the test.
Default
Operational State
Address Mode
IP Address or Host
Name
Probe Count
Traceroute Test Results
The results of the test appear at the top of the screen. The results include the Resolved IP
Address of the Destination Host Name. When the test is finished or stopped, the Overall
Result will display the result of the test, such as "Test Done," or "Max hops (=30) Finished,"
or "Test Stopped," etc. An entry shows the hop number, which is equal to the TTL, IP
address (and Host Name if available) of the gateway, and round trip time of each probe. If the
probe answers are received from different gateways, the address of each responding system
will be shown. If there is no response within a 5 second timeout interval, a "*" is printed for
that probe. If the result string exceeds 255 characters, the string will be terminated by ending
it with "Too Long."
VBrick MPEG-4 Appliance Admin Guide
The currently selected test.
Select IP Address or Host Name and enter a corresponding value.
Enter the information in the corresponding box.
Can be set from 3 to 20. The default setting is 3. This setting is the
number of probe packets sent to a host at each hop.
Diagnostics
, / , and
Refresh Start Stop
81